LSC 13105589 : GENUINE Clutch Pipe Elbow Connector (Manual Only) - NEW from LSC

Product Information

Most purchases from business sellers are protected by the Consumer Contract Regulations 2013 which give you the right to cancel the purchase within 14 days after the day you receive the item. IMPORTANT NOTE: Kindly Be Aware That This Part May Fit Some Other Vehicles Make/Models/Engine Types, Please Refer To Compatibility For Further Information As Variants Are Common In Vehicles And Compatibility Is For Guidance Purpose Only.

We are subscribed to the National Conciliation Service (NCS) which is the UK’s certified automotive retail Alternative Dispute Resolution (ADR) provider. When you depress the clutch pedal, the clutch fluid pipe (or clutch hose) transfers the hydraulic fluid into the clutch system to disengage the clutch.Stainless steel tube, Kunifer pipe, stainless steel braided TFE brake and clutch hose (with and without black PVC cover), fuel hose with neoprene cover or stainless braided outer, Acetylene and master cylinder gravity feed tube. Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). Three (that's 3) Jubillee clips on each end of the new hose made sure it couldn't slide off under pressure.

Extruded Teflon tube with stainless steel single wire braid cover (3/16" bore) commonly used for clutch systems. Use copper grease on the fitting to coat the stainless spring fingers and it might come apart next time, but don't hold your breath. I don’t know whether the hydraulic fluid in the lines is stopping me pushing it shut or if it’s something else. I belive the union on the inner wing is Imperial and the brake pipe connectors at the wishbones are metric. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging .Ah, yes requires "some force" to push all those metal fingers back can't quite remember think I jammed the big part against the car(Not plastic clip? After 2009 the pipe has a swage collar 10-15 mm along its length either end and the nylon locking plug is split into 4 for about half its length and is a clip fit on the pipe this part number plug is 215615B I may have to see if the later pipe is available of go to a hydraulic hose company and have one made. Due to its very low ratio of expansion to pressure, this hose has proved to be ideal for use on flexible lines in competition vehicle braking and clutch systems providing a desirable hard pedal with reduced travel. Extruded Teflon tube with stainless steel single wire braid cover and clear PVC outer protective cover - cover must be cut back to take fittings. When I did my clutch I dropped the seal and didnt realise that there was supposed to be a seal there!